Analysis of String Misalignment After Lamination in PV Module Production
Release time:2025-08-04
Release time:2021-09-15
Author:
Author:
During the production of photovoltaic (PV) modules, various anomalies can occur, leading to performance degradation. One severe issue is string misalignment (also known as “string overlapping”) after lamination, which can render a PV module unusable.
Below are the common causes of this issue:
1. Misapplication of Positioning Tape
Positioning tape in PV modules is primarily used to fix the solar cell strings in place on the EVA film, preventing any movement or misalignment before and during lamination. If the positioning tape is not firmly adhered, missing, or has weak adhesion, its function may fail, leading to string shifting and resulting in overlapping.
2. Vacuuming Speed
During single-chamber lamination, EVA film becomes highly flowable during the vacuuming phase. If the vacuuming speed is too fast, rapid airflow may cause EVA to move, which in turn can drag the cell strings out of position, leading to string misalignment.
3. Inflation Speed
After vacuuming in a single-chamber laminator (where the temperature is relatively low), the EVA film has low cross-linking and remains quite fluid. If the inflation (pressurization) speed is too fast, pressure from the silicone sheet is quickly applied to the module, compressing the EVA, causing it to flow and displace the cell strings, resulting in misalignment.
4. Improper Repair Procedures
During module production, defective strings from the tabbing process are sent to a repair station. If operators use incorrect repair techniques or fail to repair properly, the repaired strings may have uneven edges or “string arches.”Additionally, rough handling (such as rubbing the strings) during rechecking for cold solder joints can bend the busbars. These defects may also lead to string misalignment during lamination.
5. Overpressure and Reverse EVA Flow
If the module is laminated without a lamination frame or if the frame shifts, excessive pressure may be applied to the edges. This can cause the EVA film to flow inward under intense pressure, dragging the strings and causing overlapping. This situation is usually accompanied by “snowflake-pattern bubbles” caused by overpressure and is commonly observed near the module edges.
Previous Page
Next Page
Previous Page
Next Page