BC Cell Technology Features
Release time:2024-12-09
Release time:2021-09-15
Author:
Author:
ChinTiyanSolar offers tabber and stringer machines and stringer machines for BC cells, as well as Solar panel making machines for manufacturing BC cell modules.
The advantages of BC cell technology are primarily reflected in three aspects:
1.Structure Characteristics: The BC cell features a front surface without gridlines. This gridline-free front structure completely eliminates shading losses caused by grid electrode lines, allowing for maximum utilization of incident photons. As a result, the short-circuit current density (Jsc) is approximately 7% higher than that of conventional solar cells.
2.Module Packaging: The packaging process is more convenient and flexible, with the conventional “Z”-shaped welding replaced by a full-back “I”-shaped welding. This change avoids the complex packaging process of traditional methods and effectively improves the module's resistance to microcracks. For example, Longi’s HPBC cells show a 48% reduction in edge stress compared to traditional non-BC cells.
3.Aesthetic Appearance: The front surface has a more uniform and aesthetically pleasing color tone.
By comparing the advantages and disadvantages of PERC, TOPCon, HJT, and BC cells, it is evident that BC cells perform best in terms of stable efficiency and aesthetics. However, due to the complex manufacturing process and significant equipment investment, the production cost of BC cells is higher than that of TOPCon and HJT cell technologies.
|
Technology Type |
PERC |
TOPCon |
HJT |
IBC |
|
Structure |
The surface passivation of the cell's back side is achieved using an alumina or silicon nitride thin film, with laser openings for local preparation of the aluminum back electrode. |
The back side of the cell is passivated with a silicon dioxide tunneling layer, with no direct metal contact between the back surface and the silicon substrate, resulting in overall better passivation. |
The silicon substrate of the cell is passivated using intrinsic amorphous silicon films, with no direct metal contact on both the front and back surfaces, offering superior overall passivation. |
The front surface of the cell has no metal electrodes, and the positive and negative electrodes are arranged in a finger-like pattern on the back surface of the cell, maximizing light absorption efficiency. |
|
Relative Advantages |
Simple structure, short process flow, mature equipment, and excellent economic efficiency for mass production. |
High theoretical conversion efficiency and high compatibility with PERC technology and production lines. |
Low temperature coefficient, low light degradation, significant generation gain, relatively simple process steps, and compatibility with thinner silicon wafers. |
No metal gridlines on the front, maximizing incident light utilization and an aesthetically pleasing design. |
|
Relative Disadvantages |
Lower theoretical conversion efficiency limit, limited room for improvement. |
More process steps, relatively complex, and challenging to manufacture. |
High equipment investment, high material costs (e.g., low-temperature silver paste, indium tin oxide targets), and no mass production economic viability yet. |
More complex process and higher manufacturing difficulty. |
About CHINTIYAN
Supplier of solar panel making machine,solar panel manufacturing equipment factory from China.
Customized solutions for solar panel production lines from 5MW to 1GW.
Supply and delivery of nearly 30 types of equipment including Stringer Machines, Scribing Machines, IV Testers, EL Testers, and more.
Optimization and upgrading of outdated solar panel production line capacity.
Previous Page
Next Page
Previous Page
Next Page
